The foreguy may be referred to as a downhaul if it is attached to a bridle at the pole's midpoint, but this term is used for other parts of a boat's rigging as well. In addition, it can be used to change the shape of the spinnaker slightly to make the sail more efficient. The foreguy is used to keep the end of the pole from lifting up under heavy wind. It is attached either to the end of the pole or to a bridle on the bottom of the pole, and runs through a padeye on the foredeck rather than directly aft to the cockpit. A foreguy may also be used to control the height of the spinnaker pole.This is for a sail that is not fitted onto a stay. When the boat jibes, the spinnaker pole will be moved from one side of the boat to the other, causing the sheet to become the guy and vice versa. The purpose of this rope is create a straight front edge, luff, of the sail. This is called the sheet and serves a slightly different function. Because a spinnaker has two clews, there is always a second line identical to the afterguy attached to the leeward clew of the spinnaker. The afterguy is used to rotate the outboard end of the pole around the mast in order to optimize the sail's effectiveness, depending on the direction of the wind. The afterguy, working guy, or simply guy and sometimes known as a brace is attached to the windward clew of the spinnaker, and runs through the jaws on the outboard end of the pole and back to the cockpit.The jib has a sheet on each side, only one of which (the leeward one) will be in use at one time. The Fishermans knot It is better to use a Fishermans knot (below) through the sail.The chances of the knots getting stuck somewhere are minimal since the. The jib sheet attaches to the clew of the jib, and controls it. A mainsheet is a line connected to the boom which allows a sailor to control the speed of a boat. In a rig with no boom on the mainsail, the mainsheet would attach directly to the mainsail clew. There are two primary types of guys used to control a spinnaker pole: The mainsheet is attached to the boom, and is used to control the mainsail. On a modern sloop-rigged sailboat with a symmetric spinnaker, the spinnaker pole is the spar most commonly controlled by one or more guys. (nautical) The lower corner (s) of a sail to which a sheet is attached for trimming the sail (adjusting its position relative to the wind) the metal loop or cringle in the corner of the sail, to which the sheet is attached. Guy (red arrow), controlling the spinnaker pole.Ī guy (probably from Dutch gei, " brail") is a line ( rope) attached to and intended to control the end of a spar on a sailboat.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |